Six vertical Redwood boards fill this composite privacy gate. The leaf is nominally 3.5 ft wide by 6 ft high, with an aluminum frame and three matched hinges. Its Crossbeam identity specifies the additional overhead connection needed for this layout beside a 7 ft fence.
The crossbeam is cut from LINE stock purchased separately from the frame. Two 114-inch steel posts provide the recorded In-Ground arrangement; their dimensions should not be copied from the ordinary gate. See vertical composite fence configurations to coordinate the fixed sections. Compare composite single gates by orientation before selecting the component list: this vertical leaf needs six boards, while the horizontal Redwood gate uses eleven.
Six vertical Redwood boards fill this composite privacy gate. The leaf is nominally 3.5 ft wide by 6 ft high, with an aluminum frame and three matched hinges. Its Crossbeam identity specifies the additional overhead connection needed for this layout beside a 7 ft fence.
The crossbeam is cut from LINE stock purchased separately from the frame. Two 114-inch steel posts provide the recorded In-Ground arrangement; their dimensions should not be copied from the ordinary gate. See vertical composite fence configurations to coordinate the fixed sections. Compare composite single gates by orientation before selecting the component list: this vertical leaf needs six boards, while the horizontal Redwood gate uses eleven.
Engineering Dimensions
Nominal size (width × height): 3.5 × 6 ft.
Mounting Type: In-Ground.
Gate height: 72 inches.
Gap below the gate: 1 inch.
Post spacing (center to center): 45⅝ inches.
Clear opening between posts: approximately 42½ inches.
Post height above ground: 86 inches, excluding the post cap.
Crossbeam top: 2 inches below the post top.
Post depth below ground: 28 inches.
Concrete footing width: 12 inches min.
Hinge positions: 8 / 28½ / 8 inches.
Parts and Materials
Standard Post Cap: powder-coated aluminum.
114-inch Steel Post: powder-coated galvanized steel.
3/4" U-Channel Rubber Strip: PVC (polyvinyl chloride).
71 x 42-inch Welded Gate Frame: powder-coated aluminum.
Gate Frame Cover Strip: powder-coated aluminum.
#8 x 3/4" ST Screw: 410 stainless steel.
#8 x 1-1/4" ST Screw: 410 stainless steel.
#10 x 1" ST Screw: 410 stainless steel.
Composite Fence Board: wood-plastic composite (WPC).
Gate Stopper: powder-coated aluminum.
Gate Stop Cover Plate: powder-coated aluminum.
Hinge: powder-coated aluminum.
Groove Cover: powder-coated aluminum.
Crossbeam: powder-coated galvanized steel.
Base Connector: powder-coated aluminum.
L Connector: 201 stainless steel.
Mechanical Combination Lock: 304 stainless steel.
- Six Redwood boards run vertically in the full-privacy leaf.
- The aluminum frame is listed with three powder-coated aluminum hinges.
- The LINE crossbeam is separate from both the frame and Redwood infill.
- The source distinguishes this overhead layout from ordinary no-crossbeam installation.
- Modern Yard™ 114-inch Steel Post x 2 PCs
- Modern Yard™ 71-inch x 42-inch Door Frame x 1 set
- Modern Yard™ Redwood Fence Board x 1.5 packs (6 boards)
- Modern Yard™ Stainless Steel Mechanical Combination Lock x 1 set
- Modern Yard Line™ Fence Slat x 0.25 pack (1 crossbeam after cutting)
- Modern Yard™ Full-Privacy Hardware Kit for 1-Inch Fence Slats x 0.5 set (Base Connector x 2 PCs, L Connector x 2 PCs, #8 x 3/4" ST Screw x 8 PCs)
Limited warranty periods (residential / commercial use):
- Structural defects in Redwood boards and covered metal gate parts: up to 25 / 10 years.
- Covered Redwood board color changes: up to 25 / 10 years.
- Coastal metal coating defects: up to 5 / 3 years.
- Non-coastal metal coating defects: up to 15 / 10 years.
- Covered metal finish fading, all locations: up to 8 / 5 years.
For metal coating coverage, use the nearest shoreline of an ocean, sea or saltwater bay. Salt or brackish tidal estuaries also count. Measure in a straight line from the installed part. A distance of 10 miles or less is coastal; farther away is non-coastal.
Qualifying defects under normal use must meet the written terms, including color and coating claim conditions. Metal coverage applies only to covered parts and eligible factory finishes. The combination lock is outside the periods listed above. Contact Modern Yard for the applicable separate warranty terms.
Normal airborne coastal salt and salt spray alone do not exclude qualifying coating claims. The metal warranty excludes direct saltwater immersion or splash damage.
Remaining coverage transfers with property ownership. Products must stay at the original site. Keep records of the products and original purchase date. Transfer or replacement does not restart coverage.
For approved claims, Modern Yard refunds or replaces defective boards or parts. The original net purchase price determines the amount. The amount drops over time under the warranty schedule.
Metal coating compensation is 100% in the term’s first half, 50% in the second. Other claims follow separate schedules.
We do not pay for labor, installation, removal, reinstallation, freight or shipping. This changes if required by law or if Modern Yard expressly agrees in writing.
Email service@mymodernyard.com with purchase records, photos, product details and the issue. Expect a decision or next steps within 7–14 business days. Contact Modern Yard for full warranty terms.
Related Components
Frequently asked questions
Why does this Redwood gate have a separate Crossbeam identity?
It is the version specified for a 7 ft fence connection, using an overhead LINE member and its own post layout. The ordinary no-crossbeam gate is retained separately.
Can I use the horizontal Redwood board quantity?
No. This vertical leaf requires six boards. The horizontal full-privacy single gate uses eleven, so direction matters when selecting the component list.
Are the frame and posts supplied as one material item?
No. The frame is a separate aluminum product and the two posts are steel. Keep their individual entries when preparing the order.
You Might Also Like
In-Ground
Without Crossbeam
Style #: WPV/SGFPRD6-42X72-IG
In-Ground
Without Crossbeam
Style #: WPV/SGFPRD6-42X42-IG
In-Ground
With Crossbeam
Style #: WPV/SGDP16P01RD4DP1-42X72-CB-IG
In-Ground
With Crossbeam
Style #: WPH/SGG10RD10-42X72-CB-IG
In-Ground
With Crossbeam
Style #: WPH/SGFPRD11-42X72-CB-IG
In-Ground
Without Crossbeam
Style #: WPH/SGFPRD11-42X72-IG




























