Four upright boards and one P01 module sit in each leaf of the Charcoal vertical decorative double gate. Eight boards and two patterned steel elements form the full infill of this vertical composite double gate, with a Private Black aluminum frame around each leaf.
This composite fence gate measures nominally 7 ft wide by 6 ft high across both leaves. The clear opening is about 84¼ inches; post centers are 87⅜ inches apart.
Assembly takes place on site with two In-Ground posts and the listed shared hardware. The double gate overview offers other leaf configurations; this vertical Charcoal item retains its eight-board total and two required P01 source kits.
Four upright boards and one P01 module sit in each leaf of the Charcoal vertical decorative double gate. Eight boards and two patterned steel elements form the full infill of this vertical composite double gate, with a Private Black aluminum frame around each leaf.
This composite fence gate measures nominally 7 ft wide by 6 ft high across both leaves. The clear opening is about 84¼ inches; post centers are 87⅜ inches apart.
Assembly takes place on site with two In-Ground posts and the listed shared hardware. The double gate overview offers other leaf configurations; this vertical Charcoal item retains its eight-board total and two required P01 source kits.
Engineering Dimensions
Nominal size (width × height): 7 × 6 ft.
Mounting Type: In-Ground.
Gate height: 72 inches.
Gap below the gate: 1 inch.
Post spacing (center to center): 87⅜ inches.
Clear opening between posts: approximately 84¼ inches.
Post height above ground: 74 inches, excluding the post cap.
Post depth below ground: 40 inches.
Concrete footing width: 12 inches min.
Hinge positions: 8 / 28½ / 8 inches.
Parts and Materials
Standard Post Cap: powder-coated aluminum.
114-inch Steel Post: powder-coated galvanized steel.
3/4" U-Channel Rubber Strip: PVC (polyvinyl chloride).
71 x 42-inch Welded Gate Frame: powder-coated aluminum.
Gate Frame Cover Strip: powder-coated aluminum.
#8 x 3/4" ST Screw: 410 stainless steel.
#8 x 1-1/4" ST Screw: 410 stainless steel.
#10 x 1" ST Screw: 410 stainless steel.
Composite Fence Board: wood-plastic composite (WPC).
Gate Stopper: powder-coated aluminum.
Gate Stop Cover Plate: powder-coated aluminum.
Hinge: powder-coated aluminum.
Groove Cover: powder-coated aluminum.
Mechanical Combination Lock: 304 stainless steel.
Outdoor Gate Handle Set with Drop Rod: 304 stainless steel.
#8 x 3/4" ST Screw: 316 stainless steel.
Decorative Panel: electrocoated and powder-coated galvanized steel.
Decorative Panel Top Rail: powder-coated aluminum.
Decorative Panel Bottom Rail: powder-coated aluminum.
Decorative Panel Side Rail: powder-coated aluminum.
- Four vertical Charcoal boards fit each leaf, giving eight pieces across the gate.
- Two P01 decorative modules bring coated galvanized steel into the infill.
- Private Black aluminum frames surround the upright Charcoal boards and patterned steel in each leaf.
- Ordinary cleaning of the composite board faces uses gentle soap and water with a soft brush or cloth.
- Modern Yard™ 114-inch Steel Post x 2 PCs
- Modern Yard™ 71-inch x 42-inch Door Frame x 2 sets
- Modern Yard™ Charcoal Fence Board x 2 packs (8 boards)
- Modern Yard™ Stainless Steel Mechanical Combination Lock x 1 set
- Modern Yard™ Stainless Steel Outdoor Gate Handle Set with Drop Rod x 1 set
- Modern Yard™ 1 Foot x 6 Feet Fence Decorative Panel x 2 sets
Limited warranty periods (residential / commercial use):
- Structural defects in Charcoal boards and covered metal gate parts: up to 25 / 10 years.
- Covered Charcoal board color changes: up to 25 / 10 years.
- Coastal metal coating defects: up to 5 / 3 years.
- Non-coastal metal coating defects: up to 15 / 10 years.
- Covered metal finish fading, all locations: up to 8 / 5 years.
For metal coating coverage, use the nearest shoreline of an ocean, sea or saltwater bay. Salt or brackish tidal estuaries also count. Measure in a straight line from the installed part. A distance of 10 miles or less is coastal; farther away is non-coastal.
Qualifying defects under normal use must meet the written terms, including color and coating claim conditions. Metal coverage applies only to covered parts and eligible factory finishes. The combination lock and outdoor handle set are outside the periods listed above. Contact Modern Yard for the applicable separate warranty terms.
Normal airborne coastal salt and salt spray alone do not exclude qualifying coating claims. The metal warranty excludes direct saltwater immersion or splash damage.
Remaining coverage transfers with property ownership. Products must stay at the original site. Keep records of the products and original purchase date. Transfer or replacement does not restart coverage.
For approved claims, Modern Yard refunds or replaces defective boards or parts. The original net purchase price determines the amount. The amount drops over time under the warranty schedule.
Metal coating compensation is 100% in the term’s first half, 50% in the second. Other claims follow separate schedules.
We do not pay for labor, installation, removal, reinstallation, freight or shipping. This changes if required by law or if Modern Yard expressly agrees in writing.
Email service@mymodernyard.com with purchase records, photos, product details and the issue. Expect a decision or next steps within 7–14 business days. Contact Modern Yard for full warranty terms.
Related Components
Frequently asked questions
Is 7 ft the width of one leaf?
No. The 7 ft nominal width covers the complete pair. This is a double gate, with one frame and one P01 module assigned to each leaf.
Does the vertical design need the same board total as a horizontal decorative double gate?
No. Use eight boards for the vertical pair; the horizontal decorative double gate needs eighteen and a different board layout.
Which opening dimension should I compare with my measurements?
Use the matching basis: approximately 84¼ inches for the clear opening between posts, or 87⅜ inches between post centers. The nominal 7 ft label is a separate product-size reference.
You Might Also Like
In-Ground
With Crossbeam
Style #: WPV/DGDP16P01CH8DP2-84X72-CB-IG
In-Ground
Without Crossbeam
Style #: WPH/DGDP16P01CH18DP2-84X72-IG
In-Ground
Without Crossbeam
Style #: WPV/DGFPCH12-84X72-IG
In-Ground
Without Crossbeam
Style #: WPH/DGG10CH20-84X72-IG
In-Ground
With Crossbeam
Style #: WPH/DGDP16P01CH18DP2-84X72-CB-IG
In-Ground
With Crossbeam
Style #: WPV/DGFPCH12-84X72-CB-IG




























